6440A REV J Norge Washer Parts List

Ice maker assembly - 8 cube (refrigerator ice maker)

This icemaker can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located on the freezer door. Reuse bottom bracket from the original icemaker and attach to the new.

Temperature sensor (sensor temp ff - wr55x10025)

The temperature sensor, also known as a thermistor, helps detect the temperature inside the refrigerator and sends the information to the control board. If your refrigerator is too warm or not cooling properly, you may need to replace the temperature sensor. This is a genuine OEM part. Please make sure to disconnect the power to the refrigerator before starting your repair.

Lower dishrack wheel assembly (dishwasher dishrack roller assembly, lower)

Idler pulley assembly

The idler pulley wheel provides the tension for a multi-ribbed belt and helps the belt to rotate the drum. The drum will not spin if the idler pulley fails to put the correct amount of tension on the belt. The wheel is white in color and is made of plastic. If the drum will not tumble, is noisy, or will not start, you may need to replace this part. This idler pulley is a genuine OEM part. Please remember to disconnect the power to your dryer before you start your repair.

Bake element

This genuine OEM bake element has push-on terminal ends and provides heat while baking. If the bake element has arcing, is shorted out, the oven is not heating evenly, or little or no heat when baking, you may need to replace it. When replacing the bake element please make sure you disconnect the power to the range. Make sure you do not let the wires fall back through the rear of the oven. This element has been updated by the manufacturer. New installation screws are required and are sold separately.

Refrigerator ice and water filter (Whirlpool everydrop refrigerator water filter)

Retaining ring (sub 410233)

The retaining clip goes onto the end of the roller axle and holds the drum roller on to the axle. If the ring is broken or damaged, you will need to replace it. This is a genuine OEM part and is sold individually.

Main control board assembly (board assembly main control - wr55x10942)

This board controls the operation of the unit and is located on the back of the refrigerator. The defrost controls are built-in to the control board. If your refrigerator is too hot or cold, will not defrost, runs to long, or the ice maker will not work, you may need to replace the control board. Note: This is a genuine OEM part and has been updated by the manufacturer. It may differ in appearance but will function the same as the original.

Charcoal filter (microwave charcoal filter)

The charcoal filter is used to eliminate odors while cooking from that air that circulates through the vent. The filter measures approximately 5-inch by 5-inch and is sold individually. This is a genuine OEM part.

Lower dishrack with wheels (sub 99002396)

The lower dishrack is used to hold the dishes in place during the operation of the cycles. The lower rack measures 5.963” high x 20.46” wide x 22.39” in length. The manufacturer has made some updates to the lower rack, it no longer includes a shelf rack and now has 6 wheels rather than 8. This is a genuine OEM part.

Door handle end cap (end cap handle)

The oven door handle end cap is used to cover both the left and right-hand sides of the door handle. The end cap is black in color, made of plastic and a genuine OEM part. It is sold individually.

Drip bowl - chrome - 8 inch (narrow slot chrome drip bowl - 8")

The 8” drip bowl, also knows as a drip pan, is located under the burner element to catch anything that may drip or spill over while cooking to make clean up easier. This drip bowl measures 8” in diameter at its widest point at the top, and is chrome in color. This part works with terminal style plug in. This is just the drip bowl; the trim ring is not included must be ordered separately. This is a genuine OEM part and is sold individually.

Door shelf bar (shelf fixed ff - wr17x11889)

This shelf is designed to fit a refrigerator. It connects to the refrigerator door, and is used to hold food and beverage items. It is made of white plastic and is approximately 24 inches wide. The door shelf should snap directly into place. This part will be required if your old shelf is cracked, broken or missing.

Drive motor with pulley (motor-drve)

This drive motor operates the dryer by turning the drive belt which spins the drum and will fit most Whirlpool incorporated dryer brands before 1996. If the motor has shorted out, it will no longer turn the drum and will need to be replaced. The drive motor includes the pulley that is not available separately. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Drip bowl - 6 inch (narrow slot chrome drip bowl - 6")

Sold individually. This part is located beneath the element and catches any spills.